McWire creates a Mendel Part 1
This is no April Fools' joke! All the metal hardware was delivered yesterday and I began assembly. I got a late start so only the X-Axis is assembled. The motors are not attached, because I forgot to make a few parts and the motors driving the McWire.
A few of the holes were a little small so they were drilled out to M4. To fit the trapped nuts, I heated them with a torch and pressed them into the sockets with pliers. I used a razor blade to clean up any sloppy edges and the squished first layers on some parts.
Here are some photos of the assembly.
answer this topic
Submitted by Anonymous on Wed, 07/28/2010 - 08:49.Which way could you create the superior information about this good topic I think over? The thesis writing service will hire writers as you to perform the thesis help writing. Thus you do have a good chance to join the association of professionals.